EN
ET6298
Contact
Description générale
ET6298 is a constant current LED driver circuit with 256 steps linear current control function. Built-in 16 independent low-resistance color LED driver channels, can adjust each channel’s current. Through code selection, each channel can provide four current range: 5mA, 10mA, 20mA, 40mA. ET6298 integrate 7 band audio equalizer, subdivide 20Hz~20KHz input audio signal into 7 frequencies by built-in band-pass filters, and through the built-in high resolution ADC converts the average amplitude of each frequency value into corresponding data, control 7 output current channels. In audio synchronization mode, MCU needn’t any data operation, only need to set up the corresponding instruction, LED brightness will change along with the music beats.
Spécifications
Échantillon
Caractéristiques
- Operate supply voltage：2.4V to 5.5V
- 256 steps linear current adjust
- Provide four current range: 5mA, 10mA, 20mA, 40mA (Default 20mA)
- Use common anode LED
- I2C BUS interface, can read and write
- Any channel’s current can be adjust alone
- Half fade function, send single instruction to set fade direction
- Built-in low voltage reset function
- Built-in 7 band audio equalizers
- Built-in LED brightness will change along with the music beats
- -24~+18dB input audio signal gain adjustment
- Operate temperature range: TA=-40 to 85℃
- Package: QFN24(4mm ×4mm)
Documentation technique
| Type | Titre | Format | Date |
|---|---|---|---|
| Fiche technique | ET6298 | PDF (EN ANGLAIS) | 2025-12-16 |
