ETQ2H10011

Email Inquiry IconContact

General Description

The ETQ2H10011 device is a single channel, fully-protected, high-side power switch with an integrated NMOS power FET and charge pump. Full diagnostics and high-accuracy current-sense features enable intelligent control of the load. A programmable current limit function greatly improves the reliability of the whole system. The device diagnostic reporting has two versions to support both digital status and analog current-sense output, both of which can be set to the high impedance state when diagnostics are disabled, for multiplexing the MCU analog or digital interface among devices.

For version A, the digital status report is implemented with an open-drain structure. When a fault condition occurs, it pulls down to GND. A 3.3V or 5V external pull up is required to match the micro controller supply level. 

For version B, high accuracy current sensing allows a better real time monitoring effect and more accurate diagnostics without further calibration. A current mirror is used to source 1/K of the load current, which is reflected as voltage on the CS pin. K is a constant value across the temperature and supply voltage. The current sensing function operates normally within a wide linear region from 0 to 4V. The CS pin can also report a fault by pulling up the voltage of VCS_H.

The external high accuracy current limit allows setting the current limit value by application. It highly improves the reliability of the system by clamping the inrush current effectively under start up or short circuit conditions. Also, it can save system costs by reducing PCB trace, connector size, and the preceding power stage capacity. An internal current limit is also implemented in this device. The lower value of the external or internal current limit value is applied. An active drain and source voltage clamp is built in to address switching off the energy of inductive loads, such as relays, solenoids, pumps, motors, and so forth. During the inductive switching-off cycle, both the energy of the power supply (EBAT) and the load (ELOAD) are dissipated on the high-side power switch itself. With the benefits of process technology and excellent IC layout, the ETQ2H10011 device can achieve excellent power dissipation capacity, which can help save the external freewheeling circuitry in most cases.

The ETQ2H10011 device can be used as a high-side power switch for a wide variety of resistive, inductive, and capacitive loads, including the low-wattage bulbs, LEDs, relays, solenoids, and heaters.

ETQ2H10011 is offered in a HTSSOP14 (4.4mm ×5.0mm ) package.

Features

  • Wide voltage operation: 3.5V to 40V
  • Very low standby current: <0.5 µA
  • Input control: 3.3V and 5V logic compatible
  • High-accuracy current sense
  • Programmable current limit with external resistor: ±25% at 0.5A
  • Diagnostic enable function for multiplexing of MCU analog or digital interface
  • Overload and short-circuit protection
  • Inductive load negative voltage clamp
  • Under voltage lockout (UVLO) protection
  • Thermal shutdown/swing with self recovery
  • Loss of supply protection
  • Reverse battery protection with external circuitry
  • On- and Off-state output open- and short-to battery detection
  • Overload and short to ground detection and current limit
  • Thermal shutdown/swing detection with self recovery
  • AEC-Q100 qualified with the following results:
  • HTSSOP14 thermally-enhanced package
  • Package: HTSSOP14 (4.4mm × 5.0mm)

Technical Documentation

Type Title Format Date
Datasheet ETQ2H10011 PDF 2026-10-22

Free sample application, Provide various solutions

Samples